Safetor Corrugated or Composite Roofing Anchor
Design
The Safetor Roof Anchor Flat Surface Mounted 250 x 250 Anchor or (FSM-250) is manufactured from Stainless Steel and is riveted and bonded to corrugate or composite roofing.
We recommend using all three methods of fixing systems:
- Bonded using Sikaflex 11FC
- Riveted using 6 x 7.70 Olympic Bulb-Tite rivets complete with EPDM washer
- 2 x roof tek screws
Rated for: Fall Arrest – Abseil – Restraint
Ultimate Strength:
-
1 person – Free Fall Arrest – 15kN
2 person – Free Fall Arrest – 21kN
1 person – Abseil -12kN
System Components
Attachment system 7.70 Olympic Bulb-Tite rivets complete with EPDM washer for weather tight seal
- Shear : 680.915kg
- Tensile : 498.951kg
Attachment system 2 Sikaflex 11FC
A one component polyurethane joint sealant and adhesive.
- Tensile Strength : 0.5MPa
- Tear Strength : 1.5MPa
Testing
The load testing carried out by MTL, has shown that this type of anchor will sustain the loading required for fall arrest and abseil as per AS/NZS 5532 standards.
Installation
The installation should only to be carried out by a competent person as set out in the AS/NZS 1891.4:2009 Standards. For added strength the anchor should be sandwiched between the roofing and ridge or apron flashings. We provide a warranty on product performance of the anchor but not the structure or the roof sheeting. It is the responsibility of the installer, building designer, or building owner to ensure that the structure to which the anchor is attached will support a load as set out in Appendix F of the AS/NZS 1891.4:2009 Standard. If there is any doubt about the structures adequacy, a structural engineer should be consulted.
NB: Rivets, Sikaflex, Roof Screws & Freight not included in price.
Warning:
Only competent users who have received training should use this equipment. (Refer to the AS/NZS 1891.4:2009 recommendations concerning selection, use and maintenance.)